Abbott i-STAT 1 System Manual - page 283

9

Art: 725768-00E 

Rev. Date: 04-Jan-12

• The handheld will then display 1’s and 0’s streaming across the screen signifying that 

it is receiving the software.

Once the 1’s and 0’s disappear, the handheld display will 

again go blank for approximately 5-10 seconds.  

• A Waiting to Send message following by a Communication in Progress message will 

then appear on the handheld display.  After these messages disappear, the handheld 

display will go blank, and the update process is complete.

2.8:  Run the Electronic Simulator in the handheld.

When the simulator finishes, PASS should be displayed.

Note: If PASS is not displayed, re-run the Electronic Simulator.  If the repeated Electronic Simu-

lator attempt fails, contact APOC Technical Support.  For additional information on running the 

electronic simulator, see Section 14 of the i-STAT 1 System Manual.

Congratulations.  The process for updating the first

i-STAT 1 handheld is complete. 

Review the options below for additional instructions.

• If there are no additional handhelds to update, the process is complete:

• If there are additional handhelds to update, return to step 2.7.