Abbott i-STAT 1 System Manual - page 293
19
Art: 725768-00E
Rev. Date: 04-Jan-12
• Place the handheld in the downloader or downloader / recharger. Do NOT move the
handheld until step 4.9. A Communication in Progress message will appear on the
screen. After this disappears, the handheld display will stay blank for approximately
5-10 seconds.
• The handheld will then display 1’s and 0’s streaming across the screen signifying that
it is receiving the software.
Once the 1’s and 0’s disappear, the handheld display will
again go blank for approximately 5-10 seconds.
• A Waiting to Send message following by a Communication in Progress message will
then appear on the handheld display. After these messages disappear, the handheld
display will go blank, and the update process is complete.
4.9: Run the Electronic Simulator in the handheld. When the simulator finishes, PASS
should be displayed.
Note: If PASS is not displayed, re-run the Electronic Simulator. If the repeated Electronic Simu-
lator attempt fails, contact APOC Technical Support. For additional information on running the
electronic simulator, see Section 14 of the i-STAT 1 System Manual.
Congratulations. The process for updating the first
i-STAT 1 handheld is complete.
Review the options below for additional instructions.
• If there are no additional handhelds to update, the process is complete:
• If there are additional handhelds to update, return to step 4.8.