JBL AV2 User Manual - page 102

Appendix C

Harman Consumer Group, Inc.

C-8

6. Changing the text requires

the dual use of the number

keypad and the up/down/

left/right cursors. The

n u m b e r   k e y p a d   h a s

specific letters, numbers

and symbols defined for

e a c h   k e y,   a s   s h o w n .

Pressing the 

 and 

cursors will scroll through

the defined characters of

e a c h   n u m b e r   k e y p a d

button. Pressing the   and

 cursors changes the

position of the cursors in

the text being edited.

7. When you are finished editing, touch the text that you just edited.

“SAVED” flashes at the bottom of the display and then “SELECT”

will blink again. 

To edit any other menu options in the same menu, touch the 

next button when “SELECT” is displayed again. Repeat Steps 5 

through 7.

To edit a menu option in a different menu, press the MAIN 

button once and then repeat Steps 4 to 8.

8. When finished, exit the Setup mode by pressing the MAIN button

until the touchscreen displays MAIN in the menu heading area.

The remote control is in normal operation mode again.

Favorite Channel Access:

To access the Favorite Channel listings, press the MAIN button to

display page 1 of the Main menu. Touch the FAV (Favorite Channel)

button on the touch screen. A list of favorite TV and cable stations is

now displayed. Each option can be set to instantly select the channel

on your TV. There are five pages of eight favorite channels for a total of

40 buttons. 

Favorite Channel Setup:

Before the Favorite Channels can be selected, they must be set up for

your home theater. Follow the instructions to setup your favorite

channel listing.

1. On the remote control, press and hold the MAIN and ENT (Enter)

buttons at the same time. After about three seconds, “SETUP” is

displayed in the Menu name area at the top of the LCD

touchscreen. This is the Setup mode of the remote control.

NOTE: You now have 30 seconds to perform the next step while the

remote is in the Setup mode. If a button is not pressed within 30

seconds, the SETUP menu name will revert to MAIN, indicating that

the remote control is no longer in Setup mode. If this occurs, you will

need to repeat this step to re-enter the Setup mode.

2. Touch the FAV option to setup your favorite channels. The menu

name changes to “FAV” and the bottom of the screen flashes

“SELECT”.

3. Navigate through the FAV menus until you find the favorite

channel that you want to set up.

Note: You can customize the name of each favorite channel, if

desired. Refer to the “Customizing the Touchscreen” procedure, found

previously in this chapter.

4. Touch the favorite channel that you want to set up. The menu

name will change to display the channel name that was selected.

The bottom of the touchscreen displays “STEP 0”, indicating that

you have not yet entered the channel number.

5. Touch the menu option for the component that you will use to

enter the channel number (typically either TV, SAT or CABLE).

6. Enter the channel number using the number keypad buttons on

the remote.

Note: Some brands of televisions require an ENT (Enter) command

after the channel numbers are entered.

*+,

$%&

-./

!"#

'()

012

345

678

9:

__

 ?h