JBL AV2 User Manual - page 14

Basic Operation

Harman Consumer Group, Inc.

2-4

When the AV2 is in Standby, pressing a Zone 2 input selection

button powers on the AV2, selects the input in Zone 2, and turns off

the Main Zone.

7.  ZONE 2 OFF BUTTON

Deactivates Zone 2. When Zone 2 is off, the Zone 2 OFF button on

the front panel lights red.

8.  MAIN ZONE OFF BUTTON

Deactivates the Main Zone. When the Main Zone is off, the Main

Zone OFF button on the front panel lights red.

Note: Activating the Main Zone OFF button on the front panel turns off

the audio; however, the video continues to be output through both the

analog and HDMI video outs. If using the HDMI Video In connection, only

the HDMI video is output. If the analog Video In is used, then both analog

and HDMI video is output. Main Zone OSD (On-Screen Display) menus

are also still available.

9.  MUTE BUTTON

Mutes the Main Zone and Zone 2 volumes. Press the MUTE button to

mute the Main Zone volume level; “MUTE ON” appears in the

two-line and OSD displays. Press the MUTE button again to restore the

volume to its original level. If a front panel Zone 2 input button is held

down, then pressing the MUTE button on the front panel will mute the

Zone 2 output. 

On the remote control, pressing the volume button once while the

volume is muted turns off mute. Pressing and holding the Volume

button, while the sound is muted, resets to the original pre-mute

volume level and then increases or decreases the volume from that

point, turning off mute.

The LED in the MUTE button lights red when the Main Zone mute is

active, green when the Zone 2 mute is active, and amber when

both Zones are muted.  The volume can also be muted by using the

MUTE button on the remote control, which functions in the same

manner. However, the remote only mutes Zone 2 if the touch

screen is in the “Zone 2” menu layer.

10.  ON/STANDBY BUTTON

Toggles the AV2 between On and Standby. The rear panel Power

switch must be set to the ON position for the Standby button to be

active.  When the AV2 is in the Standby mode, pressing the Standby

button turns the unit on and changes the light in the Standby

button from red to blue. 

Power is still supplied to the AV2 when

Standby mode is activated.

When the rear panel Power switch is set to the ON position or AC

power is applied or restored, the AV2 automatically enters Standby

mode.

Note: When taken out of Standby, the AV2 activates the Zone inputs that

were active in the previous operating session.