JBL AV2 User Manual - page 79
JBL
®
Performance™ Series AV2 Audio/Video Processor
Troubleshooting and Maintenance
6-7
AV2 ERROR MESSAGES
AV2 error messages are displayed on the OSD when certain error
conditions exist. This section explains what each of these error
messages means and how to fix each problem.
VIDEO ERROR MESSAGES
The following error messages apply specifically to video issues.
VIDEO PROCESS ERROR
This error message will display
when the incoming data stream is
at a higher resolution than the
r e s o l u t i o n o f t h e V I D E O O U T
parameter. The AV2 can up-sample
a lower resolution to a higher
resolution. However, it can not
down-sample to a lower resolution
setting.
To correct the problem, right-click to return to the VIDEO OUT
Setup parameter and change the VIDEO OUT parameter to AUTO
or to a resolution setting that is higher than that of the incoming
data stream.
VIDEO FORMAT OUTPUT
ERROR
This error message will display
when the AV2 is connected to an
HDMI video monitor, but the
VIDEO OUT parameter is set to a
resolution that is not supported by
the HDMI video monitor.
To correct the problem, right-click
to return to the VIDEO OUT Setup
parameter and change the VIDEO
OUT parameter to AUTO or to a
resolution setting that is supported
by the video monitor.
HDCP VIDEO ERROR
This error message will display
when the video monitor is not
H D C P - c o m p l i a n t a n d t h e
incoming data stream requires
HDCP compliance. Typically, any
H D M I s o u r c e w i l l r e q u i r e a
HDCP-compliant video monitor.
To correct the problem, change
the incoming datastream to a
non-HDCP source or change the
v i d e o m o n i t o r t o o n e t h a t i s
HDCP-compliant.
VIDEO PROCESS NOTICE
Video input resolution
can not be higher than
video output resolution
when set to FAROUDJA.
Please adjust settings.
PRESS > TO CONTINUE
VIDEO OUTPUT NOTICE
Video output resolution
not supported by HDMI
monitor. Please select
a different VIDEO OUT
resolution.
PRESS > TO CONTINUE
Display is not
HDCP Capable
HDCP NOTICE