JBL AV2 User Manual - page 45
JBL
®
Performance™ Series AV2 Audio/Video Processor
Setup
3-19
Right channels will be sent to Zone 2 OUT with the ANALOG setting. In
this condition, DOWN MIX is not available.
The Main Zone and Zone 2 inputs are inter-related. For example,
there is only one HD input that is accessible in both the Main Zone
and Zone 2; there are NOT two separate HD inputs. Therefore, to
set the ZONE 2 OUT in a Main Zone input, the same Zone 2 input
must also be selected.
DOWN MIX is only available if the following conditions exist:
•
Zone 2 is ON (or the Zone 2 OFF button is not lit).
•
Zone 2 has the same input selected as the Main Zone.
•
If the Main Zone audio is ANALOG, it is not set to a BYPASS
listening mode.
If the ZONE-2 OUT parameter is set to ANALOG and an input has
stereo analog audio assigned to it (ANALOG 1 to ANALOG 6
connectors), then choosing that input in Zone 2 will allow it to play
the assigned ANALOG audio, regardless of what is playing in the
Main Zone.
If the ZONE-2 OUT parameter is set to DOWN MIX, selecting an
input in Zone 2 will have one of the following results:
•
If the Zone 2 input is the same as the Main Zone input, then
Zone 2 will output a DOWN MIX of the Main Zone audio.
•
If the Zone 2 input is NOT the same as the Main Zone input,
but the Zone 2 DIG AUDIO IN parameter is the same as the
selected Main Zone input, then Zone 2 will output a DOWN
MIX of the Main Zone audio.
•
If the Zone 2 input is NOT the same as the Main Zone input,
but the Zone 2 ANLG AUDIO IN parameter is set to 5.1
ANALOG or 7.1 ANALOG, then Zone 2 will output a DOWN
MIX of the Main Zone audio.
•
If the Zone 2 input is NOT the same as the Main Zone input,
but the Zone 2 ANLG AUDIO IN parameter is set to any of the
six stereo analog input connectors, then Zone 2 will output the
independent analog audio for that input.
The PC and Dock inputs are special cases that do not quite function
exactly as noted above. The ZONE-2 OUT parameter is preset to
ANALOG and cannot be changed to DOWN MIX.
Since the PC and Dock inputs operate independently of all other
inputs:
•
Either may be selected in Zone 2 regardless of what is playing in
the Main Zone.
•
Any combination of these two inputs can be selected in the
Main Zone and Zone 2, including selecting either of them for
both zones simultaneously.
•
If either of these inputs is playing in the Main Zone, the other
ANALOG input can be chosen for Zone 2.