JBL AV2 User Manual - page 43
JBL
®
Performance™ Series AV2 Audio/Video Processor
Setup
3-17
DIG AUDIO
Selects the DIG AUDIO parameter, which assigns one of the rear
panel digital audio input connectors to the current input. Available
selections include NONE, Optical 1-4, Coaxial 1-4 and HDMI 1-2.
The HDMI Audio and Video inputs, HDMI 1 and HDMI 2, are
mutually exclusive inputs – only one input is available at a time for
each input location. For example, while setting up the DVD input, if
HDMI 2 is selected for the Video Input, then HDMI 1 is not a
selectable option for the Digital Audio Input.
Note: Digital audio is not selectable for the PC and Dock inputs. Refer to
Section 5: PC and Dock Controls
for more information.
ANLG AUDIO
Selects the ANLG AUDIO parameter, which assigns one of the rear
panel analog audio input connectors to the current input. Available
selections include NONE, Analog 1-6, 7.1 Analog and 5.1 Analog.
Note: Analog audio is not selectable for the PC and Dock inputs. Refer to
Section 5: PC and Dock Controls
for more information.
DIG/ANLG AUTO
OFF, ON
Selects the DIG/ANLG AUTO parameter, which identifies if the AV2
should switch to an analog signal source for an input where the
digital input source has been interrupted. This feature is particularly
useful with certain cable set-top boxes where the signal is normally
digital but occasionally changes to analog.
The parameter, when set to ON, identifies if there is both a digital
and analog signal present to the input. If this condition is true, then
the AV2 prioritizes the digital signal over the analog signal. When the
digital signal is interrupted, then it switches to the analog signal.
Note: Digital/analog auto switching is not selectable for the Dock and PC
inputs. Refer to
Section 5: PC and Dock Controls
for more information.
MODE FAMILY
LOGIC 7, DOLBY, DTS, DSP, STEREO
Identifies the Surround Mode Family that is initially applied to the
incoming audio streams for the currently selected input. Other
surround mode families may still be applied. For more information,
refer to the “Listening Modes” section found later in this chapter.
Note: The Mode Family and Modes are connected. The Modes are driven
by the Mode Family selection as well as by the incoming audio source. The
current running data stream dictates what Mode Family options are
available for selection.
MODE
Identifies the Listening Mode that is initially applied to the incoming
audio streams for the currently selected Mode Family. Other listening
modes may still be applied. For more information, refer to the
“Listening Modes” section found later in this chapter.
Note: The Mode Family and Modes are connected. The Modes are driven
by the Mode Family selection as well as by the incoming audio source. The
current running data stream dictates what Mode Family options are
available for selection.
INPUT SETUP
SETUP
DIG AUDIO
INPUT SETUP
SETUP
ANLG AUDIO
INPUT SETUP
SETUP
DIG/ANLG AUTO
INPUT SETUP
SETUP
MODE FAMILY
INPUT SETUP
SETUP
MODE