JBL AV2 User Manual - page 30
Setup
Harman Consumer Group, Inc.
3-4
TWO-LINE OSD
OFF, 3, 4, 5, 6 SECONDS
Selects the two-line OSD parameter from the On-Screen Display
(OSD) menu. The two-line OSD parameter identifies the length of
time that the two-line OSD is displayed and can be set to display
from three to six seconds in one-second increments. If OFF is
selected, then the two-line OSD is not displayed.
Note: If OFF is selected, the menu screens are still displayed. This
parameter only affects the two-line OSD display, which is identical to the
front panel two-line display.
MENU TIME OUT
NONE, 30, 40, 50, 60 SECONDS
Selects the MENU TIME OUT parameter from the On-Screen Display
(OSD) menu. This parameter identifies the length of time before the
OSD menu times out and can be set from 30 to 60 seconds in
10-second increments. If NONE is selected, then the OSD will not
turn off automatically.
CAUTION!
The NONE selection should only be used with caution. If
the system includes a plasma display, or other display
types sensitive to image burn-in, and the OSD Menu Time
Out parameter is set to NONE, the OSD menu image can be
burned into the monitor display.
BRIGHTNESS
FULL, HALF, OFF
Selects the BRIGHTNESS parameter from the Front Panel Display
menu, which selects the brightness of the two-line front panel
display. The parameter can be set to FULL, HALF or OFF. If set to OFF,
then the front panel display is off.
On the remote control, this parameter is controlled by the
||
(Pause)
button while in the touchscreen “JBL” menu layer.
Note: When the AV2 is powered off or put into Standby mode, any
changes to the BRIGHTNESS parameter are not saved. So when the AV2 is
powered on or taken out of Standby mode again, the BRIGHTNESS
parameter will be set to FULL.
TIME OUT
NONE, 1 TO 10 SECONDS
Selects the TIME OUT parameter from the Front Panel Display menu.
This parameter identifies the length of time before the front panel
two-line display times out. The parameter can be set from 1 to 10
seconds in one-second increments. If NONE is selected, then the
two-line front panel display is always on when the AV2 is on.
DISPLAY SETUP
SETUP
ON-SCREEN DISPLAY
two-line OSD
DISPLAY SETUP
SETUP
ON-SCREEN DISPLAY
MENU TIME OUT
DISPLAY SETUP
SETUP
FRONT PANEL DISPLAY
BRIGHTNESS
DISPLAY SETUP
SETUP
FRONT PANEL DISPLAY
TIME OUT