JBL AV2 User Manual - page 13

JBL

®

 Performance™ Series AV2 Audio/Video Processor

Basic Operation

2-3

1.  FRONT PANEL DISPLAY

Use the front panel two-line display to view the current input

source, input type, listening mode, and volume level. The 2 x 20

character display also functions as a display for messages and

menus, one line at a time.

2.  IR RECEIVER

The IR receiver receives infrared commands from the AV2 remote

control. Blocking the IR receiver will prevent the remote control

from functioning properly (unless using the optional RF-1

receiver).

3.  VOLUME KNOB

Use the volume knob to adjust the volume level. The adjustable volume

range is -80 dB to +10 dB in 1 dB increments.

Note: The maximum volume level may be lower than +10 dB due to the

output level settings of the speakers.  Refer to 

Section 3: Setup

 for more

information on setting the speaker output levels.

To adjust the Main Zone volume level:

Rotate the volume knob clockwise to increase or counterclockwise

to decrease the volume level in 1dB increments. The current

volume level is indicated on the bottom right side of the two-line

front panel display.  

To adjust the Zone 2 volume level:

1. Press and hold the front panel Zone 2 input selection button that

corresponds with the current input source. For instance, if DVD is

the current Zone 2 input source, press and hold the DVD input

selection button in the Zone 2 area of the front panel.

2. While holding down the Zone 2 input button, rotate the volume

knob clockwise to increase the volume or counterclockwise to

decrease the volume. On the front panel two-line display, the

bottom left side displays that Zone 2 is selected and the bottom

right side indicates the current volume level.

Note: If you attempt to set the volume higher than the maximum or lower

than the minimum volume levels, the displayed volume level flashes.

4.  MODE BUTTONS 

Use the Mode buttons to scroll to the previous (

) or next (

)

available listening mode. Scrolling the Mode button reveals the

entire list of listening modes available for the currently selected

input and mode family.  For more information on selecting listening

modes, refer to 

Section 3: Setup.

5.  MAIN ZONE INPUT SELECTION BUTTONS

Individually select each of the 12 inputs available in the Main Zone.

When an input is selected, a blue LED lights in the corresponding

input selection button. When the Main Zone is deactivated,

pressing a Main Zone input selection button activates the corre-

sponding input in the Main Zone. 

When the AV2 is in Standby, pressing a Main Zone input selection

button powers on the AV2, selects the input in the Main Zone, and

turns off Zone 2.

6.  ZONE 2 INPUT SELECTION BUTTONS

Individually select each of the 12 inputs available in Zone 2. When

an input is selected, an amber LED lights on the corresponding

input selection button. When Zone 2 is deactivated, pressing a

Zone 2 input selection button activates the corresponding input in

Zone 2.