JBL AV2 User Manual - page 38

Setup

Harman Consumer Group, Inc.

3-12

The distances for each speaker – Front Left, Center, Front Right, Side

Right, Rear Right, Rear Left, Side Left and Subwoofers – can be set

individually. 

Note: When the speaker distance for the Front Left speaker is adjusted

above 20.0 feet from the shortest speaker distance, all speaker distances

will move in conjunction from the 20.2-feet parameter point. When the

Front Left speaker is adjusted to 20.2 feet, all other speaker distances that

are set to 0 feet will now move to 0.2 feet. If the Front Left speaker

distance is increased to 22 feet, all other speaker distances move to 2 feet

(unless they are set to a higher value). If the Front Left speaker distance is

then decreased, all other speaker distances will not change.

UNITS

FEET, METERS

Identifies the units of measure of the speaker distances. FEET and

METERS are the available selections.

OUTPUT LEVELS MENU

Selecting the MANUAL SETUP menu, OUTPUT LEVELS option opens

the OUTPUT LEVELS menu, which allows the user to manually set the

output levels for each speaker. The output levels can be set

independently for each input. The adjustable range is –15dB to +5dB

in 1dB increments.

The output levels for each speaker – Front Left, Center, Front Right,

Side Right, Rear Right, Rear Left, Side Left, Subwoofer1 and

Subwoofer2 – can be set individually. 

Note: The speaker output level settings may affect the maximum volume

level of the AV2 processor. The maximum volume level is +10dB minus the

maximum output level setting of any speaker. Thus, if your Front L/R

output levels are set to +3.0dB, then the maxium allowable volume level is

+10 dB minus 3dB, or +7.0dB.

INPUT

Identifies the input that the currently displayed output levels will be

applied to. The Input selection toggles between the currently

selected front panel input and ALL. If the front panel input is selected,

then only that input’s output levels are adjusted.

Note: To set a specific input’s output levels, the input front panel button

must be selected before the Input selection in the Output Levels menu is

available for that specific input. 

The ALL selection functions as a virtual input – it holds values that can

be assigned to all inputs. Each input can override the ALL value with

its own custom settings. To assign the ALL input, it must be selected

individually for each front panel input selection.

Note: If the input is set to ALL and the auto settings are turned to ON,

then ALL takes the preset values for its settings. The Auto Settings, if set to

ON, apply to whatever INPUT is currenly selected. 

TEST TONE

OFF, AUTO, MANUAL

Provides a noise signal to each speaker through either the AUTO or

MANUAL setting. AUTO sends a rotating noise signal to each

speaker, in the order listed in the menu. If set to AUTO, the test tone

moves in a clockwise order around the speakers, starting from the

front left. MANUAL sends the pink noise signal only to the speaker

selected by the user. The OFF selection turns off the noise signal. Any

active input source is muted while the Test Tone parameter is active

and until the Test Tone parameter is set to OFF.

The available test tones are dependent upon the current listening

mode. For example, if a 5.1-channel listening mode is active, then

the rear speakers are not accessible to the Test Tone parameter.

Note: Before activating the test tones, ensure that the AV2 is NOT muted.

If Mute is active, then the test-tone calibrations will not be accurate.

SETUP

SPEAKER/EQ SETUP

MANUAL

OUTPUT LEVELS