JBL AV2 User Manual - page 42
Setup
Harman Consumer Group, Inc.
3-16
Conv Only
– Does not apply any video enhancement or processing
to the incoming video signal, but outputs the signal in one of the
following ways, depending on the input source:
•
A standard-definition (480i or 576i) analog signal
(composite, S-video or component) is converted so
that it is available as an HDMI signal at its input
resolution, as well as at the standard S-video,
composite or component analog video outputs.
•
An analog component signal is digitized and output at
its input resolution through the HDMI outputs and as
an analog component signal, but not through the
analog composite or S-video monitor outputs.
•
HDMI signals are output through both the HDMI and
analog component outputs. Program material that
carries HDCP encoding is only available through the
HDMI output.
Bypass
– Does not apply any video enhancement or processing to
the incoming video signal, but outputs the signal in one of the
following ways, depending on the input source:
•
Analog signals (composite, S-video or component) is
output only in the resolution and format that matches
the input.
•
HDMI signals are output through the HDMI and analog
component outputs. Program material that carries
HDCP encoding is only available through the HDMI
output.
Note: If you are not getting the expected resolution options for your video
monitor, it may be caused by an incompatibility between the input setup
selections and the incoming signal. Refer to the Video Resolutions Table in
Section 6: Troubleshooting and Maintenance
for more detailed
information.
VIDEO OUT
VIDEO OUT is a multipurpose parameter; the function of the
parameter depends upon the input source and the setting of the
V-PROCESS parameter.
When the V-PROCESS parameter is set to BYPASS or CONV ONLY, the
VIDEO OUT parameter is a nonadjustable status display of the video
resolution of the output signal, as determined by the input.
When the Faroudja video processing is selected for the V-PROCESS
parameter and the output is set to HDMI or component format,
VIDEO OUT becomes an active user-selectable parameter that
identifies the video output resolution. Available selections are AUTO,
1080i, 720p and 480p.
For HDMI inputs, the AUTO option automatically selects the highest
output resolution supported by the HDMI-equipped monitor. For
component inputs with copy protection, the component output is
restricted to the resolution format of the incoming component
signal.
Note: If VIDEO OUT is set to AUTO when the component input is not
copy-protected, the component output is always set to 1080i format. If
the video monitor does not support 1080i format, the signal will not
display correctly.
INPUT SETUP
SETUP
VIDEO OUT