JBL AV2 User Manual - page 36
Setup
Harman Consumer Group, Inc.
3-10
SPEAKERS MENU
Selecting the MANUAL SETUP menu, SPEAKERS option opens the
SPEAKERS menu, which assigns independent crossover points for
each Main Zone audio output connector. Front crossover selections
affect the Sub Mode parameter options.
Manual Speaker Setup Considerations:
•
Select the crossover point closest to the –3dB low-frequency
rating of the associated speakers. For example, set the FRONT
L/R parameter to the crossover point closest to the –3dB
low-frequency rating of the front speakers.
•
Select the subwoofer crossover point equal to the lowest
crossover point of any of the other speakers.
Manual Subwoofer Speaker Setup Considerations:
All low frequencies below the speaker’s crossover point are redirected
from the speaker to the subwoofer(s). If the crossover point is FULL,
low-frequency signals, excluding LFE information, are not redirected
to the subwoofer.
Low frequencies between the Subwoofer and Front L/R speaker
channels can be duplicated. However, making this selection can
result in excessive bass. Refer to the “Sub Mode” description found
later in this chapter for more information.
Note: The Semi Autocal and Full Autocal procedures leave the Subwoofer
distance value at a default of 0.0 feet. Refer to the “Speaker Distances”
section found later in this chapter to manually set the correct speaker
distance for the subwoofers.
FRONT L/R
FULL, 40 to 120HZ
Allows the manual selection of a crossover point for the Main Zone
audio output connectors labeled Front L/R. Available selections
include FULL, 120Hz, 100Hz and 80Hz to 40Hz in 10Hz increments.
Select FULL to send a full-range signal to the front speakers.
Otherwise, select the crossover point closest to the –3dB
low-frequency rating of the front speakers.
CENTER
FULL, 40 to 120HZ, NONE
Allows the manual selection of a crossover point for the Main Zone
audio output connector labeled Center. Available selections include
NONE, FULL, 120Hz, 100Hz and 80Hz to 40Hz in 10Hz increments.
•
Select FULL to send a full-range signal to the center speaker.
Otherwise, select the crossover point closest to the –3dB
low-frequency rating of the center speaker.
•
When the speaker setup does not include a center speaker, select
NONE because some listening modes are not intended to be used
without a center channel.
SIDE L/R
FULL, 40 to 120Hz, NONE
Allows the manual selection of a crossover point for the Main Zone
audio output connectors labeled Side L/R. Available selections
include NONE, FULL, 120Hz, 100Hz and 80Hz to 40Hz in 10Hz
increments.
•
Select FULL to send a full-range signal to the Side L/R speakers.
Otherwise, select the crossover point closest to the –3dB
low-frequency rating of the Side L/R speakers.
•
When the speaker setup does not include side speakers, select
NONE to redirect side channel signals to the Front L/R output
connectors. If the Rear L/R parameter is also set to NONE, the
AV2 will redirect surround channel signals to the Front L/R
output connectors.
SETUP
SPEAKER/EQ SETUP
MANUAL
SPEAKERS