JBL AV2 User Manual - page 99

JBL

®

 Performance™ Series AV2 Audio/Video Processor

Appendix C

C-5

2. On the AV2 remote control, press and hold the MAIN and ENT

(Enter) buttons at the same time. After about three seconds,

“SETUP” is displayed in the Menu name area at the top of the LCD

touchscreen. This is the Setup mode of the remote control.

NOTE: You now have 30 seconds to perform the next step while the

remote is in the Setup mode. If a button is not pressed within 30

seconds, the SETUP menu name will revert to MAIN, indicating that

the remote control is no longer in Setup mode. If this occurs, you will

need to repeat this step to re-enter the Setup mode.

3. Touch the LEARN option to select the Button Learning Method.

The menu name changes to “LEARN” and the menu options area

now contains seven component options. The bottom of the

screen flashes “SELECT”.

4. Select the component that you want to program. If the

component you wish to set up is not on this page, touch the menu

page   arrow to select from the components on page 2.

Once a selection is made, the menu name changes to the 

selected component name.

If you want to teach any command to a component button on

the AV2 remote control, press the component button when the

menu name says “LEARN”. The menu name will change to

“READY” and the menu page area indicates the button that you

pressed. If you pressed the wrong button, press the MAIN

button to return to the Setup menu where you can start again

(return to Step 3). Once “READY” is displayed, skip ahead to

Step 6.

5. Select the component option that you want to teach the

command to 

–

 everything except for the MAIN button and the

menu page arrows can be taught. The menu name will change

to “READY” and the menu page area indicates the button that

you pressed. 

6. Press and hold the button on the other remote control that you

want to teach to the AV2 remote. When the menu name on the

touchscreen of the AV2 remote control changes to “GOOD” or

“FAILD”, release the button.

If “GOOD” is displayed, the bottom of the screen flashes

“SAVED”. The learning procedure is complete and was

successful.

If “FAILD” is displayed, try teaching the same button once

again by repeating Steps 5 and 6.

7. Repeat Steps 4 through 6 to teach the AV2 remote control any

additional button commands from the component’s remote. To

return to Step 4, press the MAIN button once.

8. When you are done teaching the JBL remote control, exit the

Setup mode by pressing the MAIN button until the touchscreen

displays MAIN in the menu heading area. The remote control is in

normal operation mode again.

Test all your new commands. If any of them don’t work, try the button

learning procedure again, keeping in mind the following suggestions:

•

Move to another room. Plasma TVs, sunlight, halogen, or

quartz lighting can interfere with the learning process.

•

Even though the old remote seems to be working fine,

replace the current batteries with fresh alkaline batteries.

•

Gradually vary the distance between the remote controls.

Try 1 inch, 2 inches and so on up to 4 feet.

•

Try tapping the button on your old remote instead of just

pressing and holding it during the learning process.

The following list provides additional information regarding the Button

Learning procedure and how the AV2 remote control behaves when

taught.

•

Learned functions override any existing preprogrammed

functions on the remote control.

•

All buttons can be taught except for the menu page arrows,

MAIN button, and LIGHT button on the side of the remote.