JBL AV2 User Manual - page 68
PC and Dock Controls
Harman Consumer Group, Inc.
5-4
DOCK FUNCTIONALITY
The optional iPod docking station allows you to enter a new world
of listening enjoyment made possible by combining the storage
capacity and playback flexibility of an iPod (not included) with the
sonic power of your AV2 processor. Operation is easy – you can use
your AV2 remote control to access and control your iPod selections.
Just one simple connection and you’re ready to go!
Note: This functionality is available ONLY if you have purchased the optional
iPod docking station. Refer to
Section 1: Getting Started
for ordering
details.
CONNECTING THE DOCK TO THE AV2
Before connecting the dock, turn the AV2 off using either the main
power switch or the Standby button.
With the AV2 off, press the button on each side of the connector at
the end of the dock cable and insert this plug into the Dock
connector on the rear panel of the AV2. The connector is keyed to
only connect in one way. If you inadvertently try to plug the
connector in the wrong way, do not force it. Simply invert the
connector and try again.
Once the Dock connector is attached to the dock accessory, select
the Dock input. The AV2 front panel two-line display indicates that
t h e i n p u t i s “ U N P L U G G E D . . . ” . T h e s t a t u s r e m a i n s a s
“UNPLUGGED” until an iPod is actually docked.
Note: The Dock Input setup displays Digital Audio as NONE, Analog Audio
as Dock (or “UNPLUGGED” if there is no iPod connected to the AV2), and
the Dig/Anlg Auto parameter is dashed out. These three parameters cannot
be changed for the Dock Input.
When the iPod is initially plugged into the AV2, the iPod goes to the
top of its music menu. When the iPod is removed, the iPod menu
goes to the root menu.
If the AV2 is in Standby mode with the Dock AUTO POWER
parameter set to ON and the iPod currently playing a track when it
is plugged into the dock, the track continues to play and the 2-line
display shows the current track information.
SELECTING THE CORRECT iPod INSERT
Each iPod model is a slightly different size, making it necessary to
use an insert that matches your specific iPod to the Dock. The Dock
is shipped with the insert for the iPod Nano Video 3rd generation
4GB/8GB model already installed; if you own this model, no further
changes are necessary.
If you own a different iPod, first select the insert that matches your
model. The model identification is printed on the back of each of
the four extra inserts supplied with the dock.
Note: The iPod Shuffle is not supported by the optional iPod docking station.
Press buttons when inserting or removing the plug.