Riso rz 510 User Manual - page 113
Advanced Features
Registering a Custom Paper Size [Custom Paper Entry]
111
11
Touch [OK] when done.
Note:
• To change a name, repeat from step 8.
12
Confirm the name and touch
[Close].
The following screen appears.
Returns to the Admin. screen. Paper size is
updated.
Tip:
Printing on Extended Paper
The machine can print on paper 17" - 21
7
/
8
" long
(for RZ590/RZ510) or 421-555 mm long (for
RZ570) (top to bottom facing the paper feeding
direction) by storing the size as a custom-size.
)
p.109
When entering a size longer than 17" (for RZ590/
RZ510) or 421mm (for RZ570) (top to bottom fac-
ing the paper feed direction) on the Custom Paper
Entry screen, the paper will be treated as
“Extended Paper”.
When “Extended Paper” is selected on the Cus-
tom Paper Entry screen, the machine switches
into “Extended Paper” mode.
Important!:
• Some Extended Paper may fail to pass through
the machine due to its paper characteristics, or
may get smudged with ink due to its image posi-
tioning. Consult your dealer (or authorized ser-
vice representative) for advice.
“Extended Paper” Mode
• When the machine is on “Extended Paper”
mode, it is indicated in the message area as
either “Ready to Make Master
“Ready to Print
• On “Extended Paper” mode, the machine can
print papers measuring 17" - 21
7
/
8
" long (for
RZ590/RZ510) or 421-555mm (for RZ570)
lengthwise from top to bottom facing the paper
feed direction. However, maximum printing
area and top/bottom Print Positioning range
remains as usual.
)
p.15
)
p.64
• Print timing and speed is different on “Extended
Paper” mode in comparison to normal printing.
This is to be expected, so do not be alarmed.
• Contact your dealer (or authorized service rep-
resentative) for suggestions about placing
paper on the Paper Receiving Trays when on
“Extended Paper” mode.
ORCH_ML_EN.book Page 111 Wednesday, November 10, 2004 7:32 PM