Riso rz 510 User Manual - page 137

Replacing Consumables

Replacing the Print Cylinder (Drum)

135

Replacing the Print Cylinder (Drum)

When replacing with a Color Cylinder (Drum) to change colors, or when removing jammed paper, follow the steps to 

remove Print Cylinder (Drum). Be sure to use a Color Cylinder (Drum) specifically designed and approved for use 

with this machine.

B

Caution:

• Do not stand the Print Cylinder (Drum) upright. Doing so may stain the floor, etc.

Important!:

• Use only Print Cylinders (Drums) specifically designed and approved for use with this machine.

• Keep the power ON while removing or replacing the Print Cylinder (Drum).

• Make sure to place the changed Print Cylinder (Drum) into the cylinder (drum) case and store horizontally.

Removing the Print Cylinder (Drum)

1 

Open the Front Cover.

2 

Check that the indicator of the Print 

Cylinder (Drum) Release Button is ON.

If the indicator is off, press the Print Cylinder 

(Drum) Release Button to turn it on.

Important!:

• When the Master Making Unit is out, the Print 

Cylinder (Drum) cannot be pulled out. Return 

the Master Making Unit into position and press 

the Print Cylinder (Drum) Release button. 

)

p.129

3 

Pull out the Print Cylinder (Drum).

Grasp the Print Cylinder (Drum) Handle and 

slowly pull until the Print Cylinder (Drum) is com-

pletely extended.

4 

Remove the Print Cylinder (Drum).

Use both hands to lift the Print Cylinder (Drum) 

straight up to remove from the rail.

Proceed with replacing the cylinder (drum), 

removing the paper jam, etc..

ORCH_ML_EN.book  Page 135  Wednesday, November 10, 2004  7:32 PM