Riso rz 510 User Manual - page 162
Troubleshooting
Troubleshooting
160
Troubleshooting
If you run into a problem, consult the following chart first to find answers before calling for a repair.
Problem
Possible Cause
Action
The machine does not start up
when the power switch is
pressed.
You may have pressed the power
switch while the machine was in the
Sleep Mode.
Try pressing the power switch again.
Before pressing the power switch, you
may want to find out whether the machine
is indeed in the Sleep Mode, by checking
the
indicator on the Control Panel. If
the
key is lit, the machine is in sleep
mode. Press the
key to end sleep
mode and to activate the machine.
Power has been disconnected.
• Check the electric cord for proper
connection to both the machine and the
power outlet.
• Check the power breaker.
The front cover is closed, but
the error message still does
not clear.
The Front Cover has not been firmly
closed.
Completely close the Front Cover. The
magnetic latch should properly engage.
The Paper Feed Tray cannot
be closed.
The Feed Paper Tray Guides have
not been widen up to the limit.
Turn the power on and lower the Paper
Feed Tray to the bottom. Set the Feed
Tray Paper Guide Lock Lever to
,
widen the Feed Tray Paper Guides up to
the limit, and close the Paper Feed Tray.
The power was turned off before the
Paper Feed Tray was lowered to the
bottom.
The Print Cylinder cannot be
placed into position.
The Print Cylinder (Drum) was
stopped at an inappropriate position
after rotation.
After manually rotating the cylinder
(drum), make sure that the
mark and
the
mark meet as shown.
The Print Cylinder (Drum) has not
been correctly set to the guide.
Set the cylinder (drum) to the guide
correctly.
)
p.137
ORCH_ML_EN.book Page 160 Wednesday, November 10, 2004 7:32 PM