Riso rz 510 User Manual - page 150
Troubleshooting
When a Message Displays
148
D00-000:Installation Error (in alphabetical order)
Message
Possible Cause
Action
Close Front Cover
The Front Cover is open or
improperly closed.
Check for the magnet underneath the
Front Cover and firmly close.
Close Master Making Unit Cover
The Master Making Unit Cover
is open or is improperly
installed.
Pull out the Master Making Unit, check
and firmly close its cover.
Install Ink Cartridge
The Ink Cartridge is improperly
installed or is missing.
Properly install the Ink Cartridge.
)
p.132
Master Making Unit has been
Unlocked
The Master Making Unit is
ready to be pulled out.
Pull out the Master Making Unit.
Print Cylinder has been Unlocked
The Print Cylinder (Drum) is
ready to be pulled out.
Pull out the Print Cylinder (Drum).
Print Cylinder Not Set in Place
Press Cylinder Release Button and
Pull Out Print Cylinder
after the Button Lights
The Print Cylinder (Drum) is
locked but not pushed in
properly.
Press the Print Cylinder (Drum) Release
Button . Remove the Print Cylinder (Drum)
after the button is lit and reinstall.
Rear Cover of Main Body is Off
Call Service
The machine rear cover is
removed.
Contact your dealer (or authorized service
representative).
Set Master Disposal Box in Place
The Master Disposal Box is
improperly set or is missing.
Properly set the Master Disposal Box.
)
p.134
Set Master in Place
No master is installed.
Install a Master Roll.
)
p.129
Set Master Making Unit in Place
The Master Making Unit is
missing or is improperly
installed.
Properly install the Master Making Unit.
)
p.129
Set Print Cylinder in Place
The Print Cylinder (Drum) is
improperly set or is missing.
Properly install the Print Cylinder (Drum).
)
p.135
Wrong-type Ink Cartridge Installed
or Cannot Read Ink Info
Replace Ink Cartridge
or Contact dealer/Riso office
Inappropriate Ink Cartridge is
installed.
Properly install a correct Ink Cartridge.
)
p.132
Important!:
• Use the Ink Cartridge specifically
designed and approved for use with this
machine. Failure to do so may cause
problems or damage to the machine.
The label on the Ink Cartridge
outlet surface has come off or
surface is with dirt.
The label on the Ink Cartridge outlet
surface contains information needed for
printing. If the machine cannot read the
information, it does not operate.
Set an Ink Cartridge that is specific to the
machine and that is with label attachment
and free from dirt.
ORCH_ML_EN.book Page 148 Wednesday, November 10, 2004 7:32 PM