Riso rz 510 User Manual - page 157
Troubleshooting
When a Message Displays
155
Original Undetected
Reset Original
(Symptom)
The machine failed to detect the original
document. The original document may
not be placed.
(Action)
Re-position the original.
Re-position the original to clear the Pop-
Up Message.
•
When resuming the print job;
Touch
[Continue]
.
(Alternatively, press the
key to print.)
•
When stopping the print job;
Touch
[Cancel]
.
(Alternatively, press the
key or
the
key to clear.)
Page Format is Larger
than Paper Size
!! Possible Ink Smudges
on Prints !!
(Symptom)
The printing paper is smaller than the
Master.
(Action)
Use a correct size printer paper.
•
When printing from the machine;
Touch
[Continue]
.
(You can also print by pressing the
key or the
key.)
•
When stopping the print job;
Touch
[Cancel]
.
(You can also stop by pressing the
key or the
key.)
Page Format is Larger
than Paper Size
!! Possible Ink Smudges
on Prints !!
(Continue->PROOF Key)
(Symptom)
The printing paper is smaller than the
Master.
(Action)
Use a correct size printer paper.
•
When printing from the machine;
Press the
key.
•
When stopping the print job;
Touch
[Cancel]
.
(You can also stop by pressing the
key or the
key.)
Processing Print Data
from PC
Linked Printers are Not
Available while Process-
ing Current Data
(Symptom)
The machine is receiving the document
data from the computer.
While the data is being transmitted, Link
Mode printing is disabled.
(Action)
Initiate the Print job after the
transmission is complete, or print from
the machine.
•
When printing from the machine;
Touch
[Close]
, then either create a
master or perform printing.
•
When you need to print in the Link
Mode;
Retry after the job has completed.
!!The Print Cylinder Type
has been Changed!!
Select the Current
Print Cylinder Type
(Symptom)
A different type of Print Cylinder (Drum)
has been installed.
(Action)
Select the type of Print Cylinder (Drum)
currently installed.
Alternatively, change back to the same
type of Print Cylinder (Drum) as before.
)
p.135
•
When changing a setting;
In the Confirm Cylinder (Drum) Type
screen, select the type of Print
Cylinder (Drum) currently installed
and touch
[OK]
.
•
When installing a different Print
Cylinder (Drum);
Pull out the Print Cylinder (Drum) and
replace with the same one as before.
When the Print Cylinder (Drum) is re-
installed, the Warning Message will
clear.
Message
Symptom/Action
How to Clear a Pop-Up Message
ORCH_ML_EN.book Page 155 Wednesday, November 10, 2004 7:32 PM