Riso rz 510 User Manual - page 139

Replacing Consumables

Replacing the Print Cylinder (Drum)

137

Installing the Print Cylinder (Drum)

1 

Place the Print Cylinder (Drum) on 

the Rail.

Align the 

 mark on the Print Cylinder (Drum) 

with the 

 mark on the guide, and place the Print 

Cylinder (Drum) horizontally onto the guide. 

Note:

• If the Print Cylinder (Drum) was manually 

rotated, be sure to turn it back so that 

 and 

marks align, after it is placed on the guide. 

2 

Return the Print Cylinder (Drum) to 

its original position.

Push the Print Cylinder (Drum) in as far as it will 

go, and then close the Front Cover.

Important!:

• Do not grasp the Print Cylinder (Drum) Handle 

when pushing in the Print Cylinder (Drum).

Tip:

Changing the Cylinder (Drum) Type 

(RZ590 

and RZ570 only)

When you install a different type of Print Cylinder 

(Drum), the Confirm Cylinder (Drum) Type screen 

appears.

1) 

Select the type corresponding to the installed 

Print Cylinder (Drum).

2) 

Touch 

[OK]

.

The Print Cylinder (Drum) type is confirmed 

and printing is enabled.

Important!:

• You will not be able to print until the Print 

Cylinder (Drum) type is confirmed.

• If you install a non-approved Color Cylinder 

(Drum), the message “Wrong-Type Print 

Cylinder Installed. Replace with Correct 

Type.” is displayed. Install a Color Cylinder 

(Drum) specifically approved for use with 

this machine.

ORCH_ML_EN.book  Page 137  Wednesday, November 10, 2004  7:32 PM