Riso rz 510 User Manual - page 167
Troubleshooting
Troubleshooting
165
Printed copies are not neatly
aligned in the Paper Receiving
Tray.
The positions of the Receiving Tray
Paper Guides and the Paper Stopper
are inappropriate.
Adjust the Receiving Tray Paper Guides
and the Paper Stopper to the size of
paper. For thick paper, slightly widen them
as necessary.
If you have adjusted the horizontal
position on the Paper Feed Tray, shift the
Receiving Tray Paper Guides in the same
direction.
)
p.31
The Paper Arrangers are not properly
set.
Set the Paper Arrangers properly.
)
p.31
Paper is not smoothly fed from
the Paper Feed Tray.
(skipped paper, or multiple-
sheet feeding)
The print paper is inappropriate.
Use paper that falls within the
recommended range.
)
p.12
The position of the Paper Feed
Pressure Adjustment Lever was
inappropriate.
When using thick or slippery paper, set the
Paper Feed Pressure Adjustment Lever to
“Thick Paper”.
)
p.28
The angle of the Stripper Plate is
inappropriate.
Turn the Stripper Plate Angle Adjustment
dial as follows;
•
When the feeding skips
Turn the dial to the left.
•
When multiple sheets are fed
Turn the dial to the right.
Important!:
• Before making the adjustment, be sure
to remove all paper from the Paper
Feed Tray and confirm that the tray has
lowered to the bottom.
The Paper Feed Adjustment on the
Functions screen is not properly set.
Adjust the “Paper Feed Adj.”. Contact your
dealer (or authorized service
representative) for details on making the
adjustment.
Problem
Possible Cause
Action
ORCH_ML_EN.book Page 165 Wednesday, November 10, 2004 7:32 PM