Riso rz 510 User Manual - page 156
Troubleshooting
When a Message Displays
154
Enter Print Quantity Over
[nn],
Programed Minimum Value
(Symptom)
You are trying to print fewer copies than
previously specified on “Minimum Print
Quantity”.
(Action)
Enter a larger number to print, or change
“Minimum Print Quantity” on the Admin.
screen.
)
p.101
Touch
[Close]
, and specify the number
of copies higher than the number
displayed on the message.
Invalid Print Cylinder
has been Selected
Change Cylinder, or
Reselect Cylinder Size
(Symptom)
You have selected a different Print
Cylinder (Drum) than the one currently
in place, as confirmed in the Confirm
Cylinder (Drum) Type screen when it
was installed.
(Action)
Select the type of Print Cylinder (Drum)
currently installed.
Alternatively, you can change the Print
Cylinder (Drum).
)
p.135
•
When changing a setting;
In the Confirm Cylinder (Drum) Type
screen, select the type of Print
Cylinder (Drum) currently installed
and touch
[OK]
.
•
When installing a different Print
Cylinder (Drum);
Pull out the Print Cylinder (Drum) and
replace with the correct one.
When the Print Cylinder (Drum) is re-
installed, the Warning Message will
clear.
!! Multi-Up is Not Available
with This Paper Size !!
Replace with Proper Paper
of Standard Size
(Symptom)
Multi-up functions cannot be used when
custom-sized paper is in the Paper Feed
Tray.
(Action)
Load standard size paper in the Paper
Feed Tray.
Touch
[Close]
.
(Alternatively, press the
key or the
key to clear.)
No Master on Print Cylinder
Make a New Master
(Symptom)
You are attempting to print, but there is
no master on the Print Cylinder (Drum).
(Action)
Set the original and create a master.
Touch
[Close]
.
Important!:
• Do not leave the Print Cylinder (Drum)
without a master. This dries out the
cylinder (drum) and causes damage.
You must either create a master or
perform a “Confidential” operation to
wrap a master around the Print
Cylinder (Drum).
!! Number of Copies
is set to "0"!!
Printing Operation will
Start on this Printer
(Symptom)
Number of print copies is set to "0", yet
“Link-Free Volume” is set to ON when
Linked Printer is connected.
(Action)
Enter print quantity.
)
p.102
•
When printing from the machine;
Touch
[Continue]
.
(Alternatively, press the
key to
print.)
•
When stopping the print job;
Touch
[Cancel]
.
(Alternatively, press the
key or
the
key to clear.)
Message
Symptom/Action
How to Clear a Pop-Up Message
ORCH_ML_EN.book Page 154 Wednesday, November 10, 2004 7:32 PM