Samlexpower EVO-2212E Owner's Manual - Section 4 |
36 | SAMLEX AMERICA INC.
SAMLEX AMERICA INC. | 37
APPENDIX A
PARAMeteR SAVe
Save all parameters to SD Card. (see Details at Section 5)
SELECT GROUP
CHARGE CURVE
SELECT GROUP
OTHER FUNCTION
PARAMETER SAVE
0 = No
POWER SAVING
1 = Enable
Up Key x 4
ò
Enter Key
ò
Up Key x 10
ò
4.9 GRoUP 6 PARAMeteR SetUP: tiMe SettinG
Please refer to Parameter "TIME SETTING" under Group 6 at Fig 4.2. Set up details are given
below.TheDateandTimeFormatisYear/Month/DayHour:Minute(24hourclock):
SELECT GROUP
CHARGE CURVE
SELECT GROUP
TIME SETTING
TIME SETTING
2000/01/01 00:00
Up Key x 5
ò
Enter Key
ò
4.10 GRoUP 7 PARAMeteR SetUP: StoP SD cARD
Please refer to Parameter "STOP SD CARD" under Group 7 at Fig 4.2. Set up details
are given below:
Once SD Card is being used, it should be removed/ejected only after the operation of the
Card has been stopped as shown below and mesage "Please remove SD Card" appears. If
the SD card is not removed within 30 sec, it will reset. After the card is removed, it reverts to
the original operating screen.
SELECT GROUP
CHARGE CURVE
SELECT STOP
SD CARD
STOP SD CARD
1 = Yes
STOP SD CARD
0 = No
Up Key x 6
ò
Enter Key
ò
Up Key x 1
ò
Please remove
the SD Card
If SD Card is not
removed within 30 sec,
the unit will reset
Enter Key
ò