Samlexpower EVO-2212E Owner's Manual - Section 5 |
42 | SAMLEX AMERICA INC.
APPENDIX A
5.4 SAVinG / UPLoADinG PRoGRAMMeD PARAMeteRS
5.4.1 Saving Programmed Parameters
All the programmed parameters can be saved on an SD Card (FAT 16 / FAT 32 Format, up to
16 GB capacity). The parameters will be saved in File named “xxxx_yyy.cfg”, where the first
group of 4 digits xxxx is the Model No. e.g. 2212 or 2224 or 3012 or 4024 and the second
group of 3 digits YYY is the Revision No. for that Model e.g. 061.
•
For saving, first insert the SD Card in the SD Card Slot.
•
Then, go to “Parameter Save” Screen (See Section 4.8 and Table 4.8 – under heading
"PARAMETER SAVE"). Steps are given below:
SELECT GROUP
CHARGE CURVE
SELECT GROUP
OTHER FUNCTION
PARAMETER SAVE
0 = No
POWER SAVING
1 = Enable
Up Key x 4
ò
Enter Key
ò
Up Key x 10
ò
•
Now, select
PARAMETER SAVE
1 = Yes
Saved file end
PARAMETER SAVE
0 = No
. The parameters will be saved and message
PARAMETER SAVE
1 = Yes
Saved file end
PARAMETER SAVE
0 = No
will be seen and then, the screen will revert to
PARAMETER SAVE
1 = Yes
Saved file end
PARAMETER SAVE
0 = No
.
5.4.2 Uploading Saved Parameters
If there is a “xxxx_yyy.cfg” file in the SD card with stored programmed parameters, then on
inserting the card, the Remote Control will ask to upload the Config File. Press Enter Button
to confirm or Back Button to cancel.
Upload conf?
Yes = Enter Key
Upload conf
1 %
Upload conf?
No = Back Key
Asks to confirm upload.
Upload conf?
Yes = Enter Key
Upload conf
1 %
Upload conf?
No = Back Key
Asks to cancel upload.
Upload conf?
Yes = Enter Key
Upload conf
1 %
Upload conf?
No = Back Key
Configuration uploading.