Samlexpower EVO-2212E Owner's Manual - Section 2  |

4  |  SAMLEX AMERICA INC.    

APPENDIX A

SECtION 2  |  

Installation

2.1 inStALLAtion GUiDeLineS

The remote control is provided with 10M/33ft, RJ-45 Data Cable (Straight Wired). Check the 

proposed routing distance of the wire and use longer wire, if necessary.

•

Flush mounting of the Remote requires appropriate cut-out in the wall/panel. Take 

necessary precautions to ensure any wiring/plumbing running behind the wall/panel is 

not damaged.

•

Route the wire to ensure there are no kinks.

•

Use appropriate grommets when the wire is passed through holes in studs/partitions to 

prevent damage to insulation. 

2.1.2 tools Required

Following tools are recommended:

• PhillipsHeadScrewdriver • Level

• HandDrill

• Knife/Saw

• Pencil

• DrillBit(2.5mm/#39)

Fig 2.1  eVo-Rc Remote cutout Dimensions

2.2 FLUSH MoUnt inStALLAtion

To flush mount, the wall opening must have at least a 2” (5 cm) depth to make room for the 

remote and cable. Also, the thickness of wall/panel board at the place of mounting should not 

be more than 13 mm to ensure that the RJ-45 jack opening is not obstructed (see Fig. 2.3).

1.  Cut an opening in the wall using the supplied paper template (based on Fig 2.1).

2.  Drillfourpilotholes(use2.5mmdiameter/#39drillbit)forthe4screws(3mmdiameter,

16mm long) that will attach the remote to wall (refer to Figure 2.1 for hole locations and 

dimensions).

3.  Route one end of the cable through wall opening to the EVO Inverter Charger, and then 

plug it into the RJ45 Remote Control Jack port on the EVO Inverter Charger.