Campbell CCFC Instruction Manual - 4. Quick Notes
CCFC Field Camera
A-1
4. Quick Notes
4.1 CCFC General
When ordering the CCFC series, use the model numbers
CCFC RS2332 or CCFC RS485 (see Sections 13 RS-232
Communications and Section 14 RS-485
Communications).
The Setup Button’s Status LED will flash when the camera
is in an Active Power State.
When the Status LED is steadily on, the camera is booting
up. Avoid interrupting this process.
Briefly pressing the Setup Button always causes the
camera to exit from any low powered quiescent states and
enables the Ethernet interface for communications. The
camera will remain in this state for 5 minutes.
An active session to the camera with a web browser
prevents the camera from entering a low powered state.
Avoid removing power from the camera when it is in an
active state. If the camera is in an active state (Status LED
is flashing), properly shutdown the camera to avoid any
memory corruption before removing power. The camera
can be shut down by holding the Setup Button
continuously for more than 10 seconds or by using the
Power Icon on the web interface.
Always ensure that all cable connectors and covers are
securely in place.
Record any changes to the IP settings of the camera. This
information is important to gain access to the camera for
focusing or reconfiguration.
The camera configuration file can be imported or exported
via the web interface. This feature can be found under
Import/Export.
Check the Campbell Scientific website for firmware
updates that may apply.