Campbell CCFC Instruction Manual - 7. Camera Hardware
CCFC Field Camera
10
Table 6-1 CCFC Factory Default Configuration
Configuration Setting
Value
Power Mode
Fully On State
Wi-Fi IP Address
10.0.01
Link Local IP
169.254.99.99
Ethernet Network IP
Address
Acquired automatically using
DHCP
Serial I/O Port
RS-232 or RS-485
RS-232 Baud Rate
115200
PakBus Address
55
There are two methods for a user to configure the CCFC camera:
using the web interface via Wi-Fi or Ethernet connection and
using the RS-232 serial lines.
Using the web interface is the best way to set up the camera.
Communicate with the camera via the Ethernet connection or Wi-
Fi in order to facilitate focusing and targeting the camera when
installed.
Setting up the camera using the RS-485 with a user-supplied
converter to RS-232 serial lines on the Power I/O cable and using
Campbell Scientific’s Device Configuration software to change
configuration parameters in the camera is an alternate to using the
web interface. Device Configuration Utility is a free download
from the Campbell Scientific (Canada) website
www.campbellsci.ca/downloads
. The use of RS-232 serial lines
requires the use of the DB9 terminal block adapter (included in
the box with the CCFC) in order to connect to a PC (Section 7.1
Power & I/O Cable Connections).
7. Camera Hardware
Ensure that the pigtail end of the power cable is properly
terminated (see Section 8 Cables/Wiring) before connecting the
power cable connector to the camera. If the power supply has an
on/off switch, it is recommended to switch the power off before
connecting the power connector to the camera.