Campbell CCFC Instruction Manual - page 80
CCFC Field Camera
A-1
Table 12-18 Access Point Settings
Variable
Toggle, Drop
Down,
Numerical, or
Text
Description
AP Name*
Text
A user friendly name that will show up when
searching for networks.
AP Channel*
Drop down
Select from 1 – 11.
Wi-Fi channel to be used for the AP. Can be
changed to reduce interference from other nearby
Wi-Fi networks.
IP Address*
Number (e.g.
10.0.01)
Camera IP address when acting as an access
point.
Netmask*
Number (e.g.
255.0.0.0)
Network mask of the Wi-Fi network to be used.
DHCP Start
Number (e.g.
10.0.010)
Start of the address range to give to connecting
clients.
DHCP End
Number (e.g.
10.0.0.19)
End of the address range to give to connecting
clients.
AP Security
None
WEP
WPA – Personal
WPA2 - Personal
The type of encryption used to secure the
network. It is strongly recommended to use
WPA2 for the highest possible security.
AP Password
Text
Used when AP Security is activated. This
password will be used when connecting to the
camera via Wi-Fi (see Section 11.1 Setup Using
Wi-Fi).
*Required.
If you find you are able to connect to the camera’s
Access Point, but cannot access the web interface, it
is recommended to disable then re-enable the
connected device’s Wireless Network Connection.
Alternately, try restarting the connected device.
Note