Campbell CCFC Instruction Manual - page 33
CCFC Field Camera
22
If unable to connect to the camera via the web
interface due to a loss of configuration information,
use the Device Configuration Utility to restore
connectivity to the camera.
The CCFC comes with a Female DB9 to Terminal block adaptor
(L28840) accessory that facilitates the connection from the Power
& I/O Cableto a 9 pin RS-232 connector. See Section 8.1 Power
& I/O Cable Connections for wiring details.
Using the Device Configuration Utility:
Connect the camera to the serial port of a PC using the
DB9 FEMALE to Terminal Block Adaptor, as shown in
Section 13 RS-232 Communications.
Once the camera is powered up (this can typically take 90
seconds), the Status LED should be flashing. If the Status
LED does not flash, the Setup Button needs to be pressed
to exit the camera from a low powered mode.
In the Device Configuration Utility, select the CCFC from
the device list and press the Connect button to connect to
the camera.
Normally, the camera is set to 115200 BAUD. If the
camera BAUD rate is set to something else, select the
appropriate BAUD rate in the Device Configuration
Utility using the control on the bottom left.
Once connected to the CCFC, use the tabs to navigate and
configure the camera.
Figure 9-1 CCFC shown in Device Configuration Utility
The camera has a large amount of variable information, so it may
take about 30 secs for the connection process to complete. Once
Note