Campbell CCFC Instruction Manual - page 23

CCFC Field Camera 

12 

7.2.1  Status LED 

The Status LED located in the center of the Setup Button provides 

some useful diagnostic information about the camera. Table 7-1 

describes the Status LED behavior. This assumes the power 

supply is between 9 - 30 Vdc. 

Table 7-1 Setup Button Status LED  

Status LED 

CCFC State 

Other 

Continuously 

Off 

No power or the camera is in 

one of the following low 

powered modes: 

  Partially On 

  Deep Sleep 

  Off Mode 

Pressing the Setup Button forces, the 

camera to exit any of the low powered 

modes and remain Fully On for a period of 

5 min with the Status LED rapidly flashing.  

Slow Flash 

1 sec on, 3 sec 

off 

Normal Operation in Fully 

On power mode. 

Rapid Flash 

Exit from low power state. 

The camera is being kept on 

by: 

  Timeout (from the 

Setup Button press) 

  Network 

Communications 

  Asserted External 

Trigger 

  Photo or video 

acquisition 

Continuously 

On 

The camera is booting up - 

this process takes 

approximately 90 sec.  

The camera will be required to boot up 

whenever: 

  Power is first applied to it. 

  The camera is exiting the Off Power 

mode to perform an operation.