Campbell CCFC Instruction Manual - page 30
CCFC Field Camera
A-1
Blue
External
Trigger
(Input)
Connect to external signal source (i.e.
datalogger control port). The external
signal wakes up or initiates photo/video
acquisition.
On a CSC datalogger, connect to a
control port (5V) or switched-12V
(SW12V) and be sure to provide a
ground.
Another device can also help keep the
camera in the Fully On power mode by
leaving the External Trigger Input
activated.
Connect to
ground if left in
Factory Default
settings
Clear* Shield
Shield/Earth Ground.
* Required.
External trigger also turns on the Wi-Fi from any low
power mode, when it is changed to Active State. The
camera can be configured to turn on when a signal is
set to high or low. This is a user selectable
configuration. The blue wire needs to be connected to
a 5 or 12 Vdc source.
8.2 Power & I/O Cable Details
The Power & I/O cable (CCFCCBL1-L) that is used for the
CCFC camera has an outdoor environmentally rated connector on
one end and discrete wire pigtails on the other that allow for
flexible termination. When making the cable connection to the
camera, the notch positions must always line up and care should
be taken not to cross-thread the connector.
For information about the available cable options, see Appendix
A.
20-AWG 1 pair, 24-AWG 2 pair Shielded Cable with
Santoprene jacket.
IP-68 rated connector at the camera end.
10 inch pigtail for termination at the datalogger end.
Note