Campbell CCFC Instruction Manual - page 22
CCFC Field Camera
A-1
When power is first applied to the camera, the Status LED on the
Setup Button will turn on and remain steadily on for about 90
seconds. Once the Status LED starts flashing, the camera has
properly initialized and is ready for operation (see Section 7.2
Setup Button/Status LED).
Figure 7-1 CCFC Connector Layout
7.1 Power I/O Connection
Connection to the Power I/O (9-30 Vdc) is necessary for camera
operation, as it is the only means to supply power to the camera.
The Power I/O cable provides a weather-tight connection and has
an IP68 environmental rating when properly connected. Even
when the camera is not in use, the power cable must be left
connected, if the camera is to be left installed.
When connecting the cable to the camera, the notch positions
must always line up.
7.2 Setup Button/Status LED
The Setup Button is located behind a protective cap on the
camera. The Setup Button also contains an integrated Status LED
for user feedback.
Ethernet
Power I/O
(9-30 Vdc)
Setup Button
and Status
LED
Antenna