Campbell CCFC Instruction Manual - page 90
CCFC Field Camera
A-1
Table 12-23 Camera Power Modes
Power
Mode
Ethernet
Power Save
Mode
Operating Characteristics
Fully On
Always On
Camera is always on.
Highest power consumption.
Ethernet is on and always available for incoming communications.
Moderate
Power Save
Mode
Not recommended.
Full Power
Save
Camera is always on.
Average power consumption is reduced by 50mA @ 12 Vdc.
The Ethernet is normally turned off and is only enabled when
outgoing communications are required (email or FTP).
User needs to push the Setup Button to temporarily enable the
Ethernet port for web page access.
Partially On
Always On
The camera is effectively off in a low powered state.
Typical power consumption is 90 mA @ 12 Vdc.
Ethernet is on and always available for incoming communications.
The camera will temporarily wake up to the fully on power mode
when traffic occurs on the network.
Warning: In situations where there is constant network traffic, the
camera may effectively be in the Fully On power mode.
Moderate
Power Save
Mode
The camera is effectively off in a low powered state
Typical power consumption is 60 mA @ 12 Vdc
Ethernet is always off
Disconnecting and connecting the camera to another Ethernet device
will momentarily wake up the camera to allow it to process
incoming communications. The camera will go into the low
powered mode again – if no communications occur.
Full Power
Save Mode
The camera is effectively off in a low powered state.
Average power consumption is typically 10 mA @ 12 Vdc.
The Ethernet is normally turned off and is only enabled when
outgoing communications are required (email or FTP).
User needs to push the Setup Button to temporarily enable the
Ethernet port for web page access.