L3 Comminications SERIES 5000 Operation And Maintenance Manual - page 100
Targets And Target Management
4-41
4.15 Targets And Target Management
By placing the pointer over a target in the Sonar Viewer window and
double-clicking, you can log a target into a target catalog, open a Target window
for the target as shown in Figure 4-54, and place a target mark in the Navigation
Window. You can use the Target window to zoom, pan, save, get the exact
location, and adjust the TVG gain and color palette of the target. You can also
select a target classification, such as a cable, rock, pipe, or wreck. Coordinates
around the edge of the target window are measured in meters or feet. For target
catalog setup information, refer to “Setting up the User Preferences” on page 4-48.
4.15.1 Setting up the Target Window Properties
Right click on the Target window to open the Target Properties dialog box to the
Target Gain tab as shown in Figure 4-55. On this tab use the
Intensity
slider to
adjust the gain of the target data being displayed. Click
Use Original Gain Value
to
select the default gain.
Figure 4-54:
The Target Window
Figure 4-55:
The Target Properties Dialog Box—Target Gain Tab