L3 Comminications SERIES 5000 Operation And Maintenance Manual - page 68
Survey Wizard
4-9
On the Target Catalog Location page shown in Figure 4-10, you are asked to
specify information for the target catalog. In most cases the default should be used.
You can also specify a reference catalog to be used to place historical targets on
the page for comparison. You must browse for a previous catalog.
On the Target Parameters page shown in Figure 4-11, you are asked to set a target
name prefix. This is the prefix that will appear for the target in the target window
when a new target is generated. Again, in most cases you should use the default.
You may want to change the prefix if you have a unique requirement. You also
have the option of selecting a new layer. If you will be using the targets in
conjunction with a reference target catalog you might want to set the new targets
on a different layer. In this case they will have a different color and will be easily
identified.
On the Survey File Location page shown in Figure 4-12, you are asked to either
create a new survey grid or route file or load a previously created survey route or
grid. The
Create a new survey grid or route file
selection is the default. It will
generate a default survey grid and put it in the default file location shown. You can
edit this if needed, but it is suggested that you use the default. If you already have a
survey route or grid for the survey area, the
Load an existing survey grid or route
file
selection gives you the opportunity to browse to the file and have it loaded on
startup.
Figure 4-10:
The Survey Wizard—Target Catalog Page