L3 Comminications SERIES 5000 Operation And Maintenance Manual - page 130
Operating the Wing
4-71
angle is displayed in degrees in one-degree increments in the display below the
slider as shown in Figure 4-81. Then click
Start Motion
. The wing moves to the
desired angle as indicated both by the wing graphic and the display in the graphic
as shown in Figure 4-82. Movement of the wing can be stopped at any time by
clicking
Stop Motion
.
To immediately move the wing to its horizontal position in just one operation,
click the button to the right of "0" on the slider; to immediately move the wing to
its maximum angle, click the button to the right of "17." Again, movement of the
wing can be stopped at any time by clicking
Stop Motion
.
If maneuvering of the mouse or pointing device is awkward or difficult, you can
use an alternate method of setting the wing angle. To set the angle of the wing
using this method, use the up or the down arrow key on the keyboard to move the
slider. Each click of an arrow key moves the slider one degree. Then click Enter.
The wing moves to the desired angle. Movement of the wing can be stopped at any
time by clicking Enter again.
Figure 4-81:
Choosing the Wing Angle
Figure 4-82:
Wing Angle Set