L3 Comminications SERIES 5000 Operation And Maintenance Manual - page 257
D-54
APPENDIX D General Setup, Configuration and Troubleshooting
Series 5000 Sonar System Operations and Maintenance Manual
P/N 11210060, Rev. 13.0
D.9 Software Troubleshooting
If for some reason SonarPro will not open, or SonarPro gets saved in some
corrupted condition and will not operate, you can recover to the default installation
condition by editing the operating system’s Registry.
To edit the registry:
1.
Select Start/Run, enter REGEDT in the
Open
text box, and then click
OK
.
2.
Navigate the path My Computer/HKEY_CURRENT_USER/Software/Klein
Associates.
3.
Select and then delete SonarPro.
4.
Start SonarPro, and then select New State from the Session Menu.
To totally remove C-Maps from the registry:
1.
Select Start/Run, enter REGEDT in the
Open
text box, and then click
OK
.
2.
Navigate the path My Computer/HKEY_CURRENT_USER/Software.
3.
Select and delete C-Map.
4.
Navigate the path My Computer/HKEY_LOCAL_MACHINE/Software.
5.
Select and delete C-Map.
6.
Select and delete Aladin.
D.10 Terminating an Optical Fiber
When terminating optical fibers, use a termination kit such as the Fotec
Fiber-Optic Termination Kit.
To terminate an optical fiber:
1.
Plug oven in.
2.
Place a piece of tape on the table to catch the fiber when cut.
3.
Mix epoxy.
4.
Put epoxy into the syringe.
5.
Slide the strain relief over the fiber.
WARNING
Safety glasses should be worn when handling optical fiber. In
addition, when handling broken fiber, use extreme caution as the fiber can
easily penetrate clothing and skin causing injury and infection.