L3 Comminications SERIES 5000 Operation And Maintenance Manual - 6.4
Specifications
6-11
5.
Wait for the network connection to establish communications with the computer.
6.
Switch the RUN/STAND BY switch to RUN.
7.
The boot sequence will begin, and when completed, the CARRIER LOSS and
LOCK LOSS indicators on the Demultiplexer board will turn off. These
indicators can be viewed through the view ports on the connector panel of the
TPU.
6.4
Specifications
The specifications for the Splashproof TPU, except for those listed below, are the
same as the rack mount TPU. Refer to CHAPTER 2: “Specifications,” for those
specifications.
Power consumption:
250 VA (nominal)
Input voltages:
115 or 230 VAC, 50–60 Hz, manually
selected; or +12 VDC at 12 A
Size:
52.5 cm (20.7 in.) wide
21.7 cm (8.5 in.) high
43.6 cm (17.2 in.) deep
Weight:
16.4 kg (36 lb)
Operating temperature:
0–40
° C with vent open; 0–30° C with
vent closed
Ingress protection:
Designed to IP-66 with vent closed;
IP-56 with vent open
6.5
Splashproof TPU Drawings
Listed in Table 6-1 are the drawings for the Splashproof TPU. They are provided
for reference and troubleshooting purposes.
NOTE
Specifications are typical and subject to change without notice.