L3 Comminications SERIES 5000 Operation And Maintenance Manual - page 91
4-32
CHAPTER 4 SonarPro Ver. 11.0 Operating Instructions
Series 5000 Sonar System Operations and Maintenance Manual
P/N 11210060, Rev. 13.0
Mag All
Click this button to quickly zoom out to display all of the data collection tracks,
targets and the survey route.
Zoom Window
Click this button to select an area in the Navigation window to zoom in on.
Align Survey Route
This button is only active with the C-MAP charts or no charts. Click the button
once to rotate the view so the survey grid is oriented up and down. The current ship
heading, if following the survey grid, will be up. This is a good function for use by
the person steering the boat on a survey grid. Click the button a second time to
rotate the chart 180 degrees. Right-click in the Navigation window to open the
Navigation Properties dialog box to the General tab and select the
Display Survey
Route
and
Display Compass Rose
check boxes to display the survey grid and the
compass rose for orientation.
Align North
This button is only active with the C-MAP charts or no charts. Click the button to
align north up.
Location
Click this button to move the cursor over to a location of interest in the Navigation
window. The location of the cursor will be displayed in the Status bar in the Main
window.
Distance
Click this button to locate the bearing and distance to a previous target. Click the
button, move the cursor to a start point, hold the left mouse button down and drag
to the target or end location. The position, bearing and distance information will be
displayed as shown in the example in Figure 4-41.
ID Target
Click this button to identify the targets that you have selected or marked in the
Navigation window. Click the button, place the cursor over the target and hold the
mouse button down to view the target. Releasing the mouse button will erase the
target image. The data image of the target will appear in the Navigation Window.