L3 Comminications SERIES 5000 Operation And Maintenance Manual - page 105
4-46
CHAPTER 4 SonarPro Ver. 11.0 Operating Instructions
Series 5000 Sonar System Operations and Maintenance Manual
P/N 11210060, Rev. 13.0
4.15.4 Target Measurement
In the Target window on the right side is a list of measurement parameters as
shown in Figure 4-54 on page 4-41: Lat/Lon, Length, Width, Height1, and
Height2. These are all active tools. Click a parameter to activate it, move the
cursor to the target, and then click and drag to make the desired measurement.
The
Outline
button operates the same as the one in the Sonar Viewer window.
Click the button, and with your mouse, outline a target. The outline will be placed
in the Target window as well as in the Navigation window. Right-click in the
Navigation window, select the Chart Properties tab in the Navigation Properties
dialog box, and lower the
Chart Palette Control
to see the outline. To erase
outlines, right-click in the Navigation window, select the General tab and click
Erase Outlines
.
At the bottom of the Target window there is a text box for entering notes about the
target. The target can also be renamed from its default name by entering the name
in the
Name
text box.
4.16 Towfish Sensor Information
Sensor
Click this button to display towfish sensor information. The Sensor window will
open as shown in Figure 4-60.
Figure 4-60:
The Sensor Window