Lantech LGS-2624C User manual - page 138
2-9 Fitering Data Base
Fitering Data Base Configuration gathers many functions, including MAC
Table Information, Static MAC Learning , which cannot be categorized to
some function type.
MAC table
Switching of frames is based upon the DMAC address contained in the
frame. The switch builds up a table that maps MAC addresses to switch
ports for knowing which ports the frames should go to ( based upon the
DMAC address in the frame ). This table contains both static and dynamic
entries. The static entries are configured by the network administrator if the
administrator wants to do a fixed mapping between the DMAC address and
switch ports.
The frames also contain a MAC address ( SMAC address ), which shows
the MAC address of the equipment sending the frame. The SMAC address
is used by the switch to automatically update the MAC table with these
dynamic MAC addresses. Dynamic entries are removed from the MAC
table if no frame with the corresponding SMAC address have been seen
after a configurable age time
2-9.1 Configuration
The MAC Address Table is configured on this page. Set timeouts for entries
in the dynamic MAC Table and configure the static MAC table here.
Web Interface
To configure MAC Address Table in the web interface:
Aging Configuration
1. Click configuration .
2. Specify the Disable Automatic Aging and Aging Time.
3. Click Save.
MAC Table Learning
1. Click configuration .
2. Specify the Port Members(Auto,Disable,Secure).
3. Click Save.
Static MAC Table Configuration
1. Click configuration and Add new Static entry .
2. Specify the VLAN IP and Mac address ,Port Members.
3. Click Save.