Lantech LGS-2624C User manual - page 194
2-16.11 Storm Control
The section allows user to configure the Storm control for the switch. There
is a unicast storm rate control, multicast storm rate control, and a broadcast
storm rate control. These only affect flooded frames, i.e. frames with a
(VLAN ID, DMAC) pair not present on the MAC Address table. The
configuration indicates the permitted packet rate for unicast, multicast or
broadcast traffic across the switch
Web Interface
To configure the Storm Control Configuration parameters in the web
interface:
1. Click Configuration, QoS, Storm Control Configuration
2. Evoke to select the frame type to enable storm control
3. Scroll to set the Rate Parameters
4. Click the save to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Parameter description:
Frame Type
The settings in a particular row apply to the frame type listed here: Unicast,
Multicast or Broadcast.
Enable
Enable or disable the storm control status for the given frame type.
Rate
The rate unit is packets per second (pps). Valid values are: 1, 2, 4, 8, 16, 32,
64, 128, 256, 512, 1K, 2K, 4K, 8K, 16K, 32K, 64K, 128K, 256K, 512K or
1024K. , 1024K, 2048K, 4096K, 8192K, 16384K or 32768K. , 1024K, 2048K,
4096K, 8192K, 16384K or 32768K.
The 1 kpps is actually 1002.1 pps.