Lantech LGS-2624C User manual - page 91
2-5.2 VLAN Configuration
The section describes the VLAN configuration setting process integrated
with IGMP Snooping function. For Each setting page shows up to 99 entries
from the VLAN table, default being 20, selected through the "entries per
page" input field. When first visited, the web page will show the first 20
entries from the beginning of the VLAN Table. The first displayed will be the
one with the lowest VLAN ID found in the VLAN Table. The "VLAN" input
fields allow the user to select the starting point in the VLAN Table. Clicking
the button will update the displayed table starting from that or the next
closest VLAN Table match.
Web Interface
To configure the IGMP Snooping VLAN Configuration in the web interface:
1. Click Configuration, IGMP Snooping, VLAN Configuration
2. Evoke to select enable or disable Snooping , IGMP Querier
Specify the parameters in the blank field.
3. Click the refresh to update the data or click << or >> to display previous
entry or next entry.
4. Click the save to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Parameter description:
Snooping Enabled
Enable the Global IGMP Snooping.
Unregistered IPMC Flooding enabled
Enable unregistered IPMC traffic flooding.
Leave Proxy Enabled
Enable IGMP Leave Proxy. This feature can be used to avoid forwarding
unnecessary leave messages to the router side.