Lantech LGS-2624C User manual - page 31
1-5 Syslog
The Syslog is a standard for logging program messages . It allows
separation of the software that generates messages from the system that
stores them and the software that reports and analyzes them. It can be
used as well a generalized informational, analysis and debugging messages.
It is supported by a wide variety of devices and receivers across multiple
platforms.
1-5.1 Configuration
This section describes how to configure the system log and provide a wide
variety of devices and receivers across multiple platforms.
Web Interface
To configure Syslog configuration in the web interface:
1. Click SYSTEM, Syslog.
2. Specify the syslog parameters includes IP Address of Syslog server
and Port number.
3. Evoke the Sylog to enable it.
4. Click Save.
Parameter description:
Server Mode
Indicates the server mode operation. When the mode operation is enabled,
the syslog message will send out to syslog server. The syslog protocol is
based on UDP communication and received on UDP port 514 and the
syslog server will not send acknowledgments back sender since UDP is a
connectionless protocol and it does not provide acknowledgments. The
syslog packet will always send out even if the syslog server does not exist.
Possible modes are:
Enabled: Enable server mode operation.
Disabled: Disable server mode operation.