Lantech LGS-2624C User manual - page 68
2-3 Aggregation
2-3.1 Static Trunk
The Aggregation Configuration is used to configure the settings of Link
Aggregation. You can bundle more than one port with the same speed, full
duplex and the same MAC to be a single logical port, thus the logical port
aggregates the bandwidth of these ports. This means you can apply your
current Ethernet equipments to build the bandwidth aggregation.
2-3.1.1 Static Trunk
Ports using Static Trunk as their trunk method can choose their unique
Static GroupID to form a logic
―trunked port‖. The benefit of using Static
Trunk method is that a port can immediately become a member of a trunk
group without any handshaking with its peer port. This is also a
disadvantage because the peer ports of your static trunk group may not
know that they should be aggregate together to form a
―logic trunked port‖.
Using Static Trunk on both end of a link is strongly recommended. Please
also note that low speed links will stay in
―not ready‖ state when using static
trunk to aggregate with high speed links.
Web Interface
To configure the Trunk Aggregation Hash mode and Aggregation Group in
the web interface:
1. Click Configuration, Aggregation, then Hashmode
2. Evoke to enable or disable the aggregation Hash mode function.
Evoke Aggregation Group ID and Port members
3. Click the save to save the setting
4. If you want to cancel the setting then you need to click the reset button. It
will revert to previously saved values.