QuVIS Acuity User Manual - Product Damage Precautions
Product Damage Precautions
CAUTION:
To avoid product damage, replace battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to manufacturer’s instructions.
Power Source
To prevent electrical shock or fire hazard, this product should be operated only with the type of power source
indicated on the label.
Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or
against them.
To avoid electrical shock or fire hazard do not overload wall outlets, extension cords, or convenience receptacles on
other equipment.
Proper Ventilation
Slots and openings in the product chassis are provided for ventilation. These ensure reliable operation of the
product and prevent it from overheating. Do not block or cover these openings.
Use Electrical Surge Protection
To avoid product damage caused by electrical power surges, plug this product into an appropriately rated surge
protection device.
Avoid Sources of Heat
This product should be placed more than one (1) foot away from heat sources such as radiators, heat registers,
stoves, and other products (including amplifiers) that produce heat.
Connecting to Other Equipment
To avoid electric shock, this product should be turned off when making connections between this product and other
equipment.
Service Safety Information
WARNING!
To avoid personal injury, do not attempt to service this product yourself. The service instructions in this document
are intended for properly trained service personnel only. Refer all service to qualified personnel.
CAUTION:
To avoid electrical shock, avoid exposed connections and disconnect the main power by removing the power cord
before removing protective panels or product components.
Request Product Servicing
Unplug this product from the power outlet and refer service to qualified personnel under the following conditions:
A) When the power supply cord or plug is damaged.
B) If liquid has been spilled, or objects have fallen on the product.
C) If the product has been exposed to water or wet conditions.
D) If the product does not operate normally by following the operating instructions. Adjust only those controls that
are covered in the User Manual.
E) If the product has been dropped or damaged in any way.
F)
When the product exhibits a distinct change in performance – this indicates a need of service.
QuVIS Acuity
™
Page 10
QSR Version 3.3