QuVIS Acuity User Manual - page 155

ADVANCED SETUP (2/2) menu page 

This menu page contains advanced system and editing settings. The advanced settings found on this menu page 

will likely only need to be periodically changed depending upon the requirements set forth by a facility or editing 

project. 

Record Video Adv Options 

Description 

Use this toggle control to turn on/off SCSI polling. SCSI polling is a 

system service that monitors for the removal of active volumes to 

protect the file system from potential corruption. If a drive is removed, 

the system will automatically unmount that volume. Additionally, the 

system will detect if a drive has been inserted and will automatically 

mount that drive, provided that the device ID is already recognized. 

SCSI polling 

Fast – This deletion method removes the file pointer information from 

system’s File Allocation Table (FAT) but does not remove the physical 

data from the disk drive. The physical space the deleted file occupies 

on the hard drives may be overwritten in subsequent write operations. 

If this hard drive space has not been reused, then it’s possible to 

recover the deleted file using the Recover command. 

Delete Method 

Secure– This deletion method permanently removes the file from the 

system’s File Allocation Table and performs a destructive write over the 

hard drive area occupied by the deleted file. Once a file has been 

deleted using this Secure method, the file is unrecoverable. 

Disk space warning level 

This user definable value is used to instruct the system to issue a low 

disk space warning if the amount of available storage is less than the 

set value. If the user creates a Virtual Tape (VTP) and the amount of 

available storage space is less than the defined threshold, the system 

will issue a warning.  

Once a low-space warning message has been displayed you will be 

given the option to either continue or cancel the operation. 

Enable DA5..DA8 

This control is used to activate Digital Audio channels five through eight 

(5 – 8) for VTP editing. All digital audio channels will be available for 

editing by default. 

Smart TSO response 

This control gives the QuVIS Acuity the ability to learn what time code 

the controller wanted it to go to, and to respond with the intended 

QuVIS Acuity

™  

Page 154 

QSR Version 3.3