QuVIS Acuity User Manual - page 21

Configuring for basic PLAY operation 

There are many aspects of the factory setup that may not apply to your installation or application. Therefore, you 

will want to “walk-through” the main menu screens not only to setup the QuVIS Acuity for your application but also 

to familiarize yourself with its broad feature set. 

Use the following procedures to configure the QuVIS Acuity for basic playback operations under local control. 

For complete configuration procedures refer to

Chapter 4 – Front Panel GUI Interface

and 

Chapter 5 – Modifying 

Configuration

.  

Configuration tasks: 

• 

Select Video Output Settings

• 

Select Audio Output Settings

Select Video Output Settings 

1. 

Navigate to the Play Video menu page. 

2. 

Make the appropriate configuration changes in the Video Outputsection. 

a. 

Set the LTC (Linear Timecode) out type. 

No LTC output – No timecode will be output. 

Original Source LTC – Recorded LTC timecode, saved as part of the media file, will be output. 

Absolute starting from 0 – Timecode starting at 00:00:00:00 will be output. 

b. 

If playback is used in an editing environment, Metadata information (SMPTE RP-215) may be output. 

Choices include: 

Original source LTC – Timecode recorded as Metadata will be output. 

Same as LTC output – Use the same signal that LTC output is set to use. 

c. 

If necessary, set the SDI Output Colorspace. 

QuVIS Acuity

™  

Page 20 

QSR Version 3.3