QuVIS Acuity User Manual - page 194
Insert Edit (Record) into a Virtual Tape from the GUI
This feature enables one to locally record (edit) into a Virtual Tape (VTP) from the front panel GUI in a process
similar to locally recording on a VTR.
Requirements
•
Virtual Tape
•
Video and/or audio source and appropriate connections
1.
From the Play Browser 1/5 menu page, select the virtual tape file.
2.
Change the playstyle to Play Jog/Shuttle and begin playback by pressing the VTR PLAY button.
3.
Using the Jog/Shuttle wheel and transport buttons, locate the TCV timecode inpoint (inclusive) for the record
session and PAUSE on that position.
4.
Press the REC button once to switch to the Record menu group. Press REC a second time to arm the system
for an insert edit. The transport status on the dashboard will change to [VTP-INSERT] to indicate that the
system is in a VTR insert record wait state.
5.
Once the system is armed for the local insert edit, final changes to the record settings, such as selecting the
number of audio channels to be recorded, may be made if needed. Additionally, the system may be setup to
start and/or stop the Local Insert Edit at a specific time or interval using the record trigger functionality found on
the Record Advanced 4/5 menu page.
6.
Press PLAY+REC to begin recording onto the virtual tape.
7.
Press the STOP button to end the insert edit. Once recording has stopped, the system will automatically place
the virtual tape under Jog/Shuttle play control at the end of the recording that was just made. The newly
recorded assets are now available for playback.
8.
If additional recordings are required, repeat steps 3 – 7.
QuVIS Acuity
™
Page 193
QSR Version 3.1