QuVIS Acuity User Manual - page 90
Note: You may also use the VTR buttons (FWD or REV) located above the Jog/Shuttle wheel to frame-step through
the clip in the direction specified by the button press. Each time the button is pressed, the clip will be advanced to
the previous (REV) or next (FWD) frame.
4.
Normal playback of a clip under Jog/Shuttle control may be resumed either by rotating the shuttle wheel to the right
of the center indent until the Dashboard displays “PLAYING” or by simply pressing the PLAY button directly above
the jog/shuttle wheel.
5.
Playback of a clip under the Jog/Shuttle playstyle is similar to controlling playback of videotape. If the end of the clip
is reached the clip remains loaded waiting for additional transport instructions. To end playback of a clip under
jog/shuttle control, the STOP button must be pressed twice.
The first press of the STOP button will halt playback control of the clip and place it in a PAUSED state.
While in the PAUSED state, playback (shuttle) or frame-step (jog) control of the clip may resume by using the
appropriate controls (VTR transport buttons or Jog/Shuttle wheel) or the clip may be unloaded from jog/shuttle
control and playback halted by pressing the STOP again.
6.
During playback of a clip under the Play jog/shuttle playstyle, the navigation pointer is hidden in order to ensure
proper control of the virtual jog/shuttle wheel. To activate the pointer and navigate elsewhere within the GUI
(without existing jog/shuttle), tape the touchpad once. The pointer will appear and you may navigate other screens
(remember to return to PLAY 5/5 so that you can exit jog/shuttle playback afterward).
To restore jog/shuttle control after re-displaying the pointer, tap the touchpad again (while on the PLAY 5/5 menu
page) to hide the pointer.
Note: Activating/deactivating the pointer will not work if the touchpad TAP function has been disabled on the
SETUP GUI menu screen (Setup menu page 3/8).
Clip-based Script Authoring
On the Play Jog/Shuttle menu page are four controls that can be used to create a mini-script (single play event
only) by marking an In Point and Out Point for a collapsed (interleaved audio and video) clip.
1. To set the In Point play (Shuttle or Jog) the current clip and stop on the desired frame (timecode position).
2. Press the Mark In soft button.
3. To set the Out Point, play (Shuttle or Jog) the current clip and stop on the desired frame (timecode position).
QuVIS Acuity
™
Page 89
QSR Version 3.3